Embroidered patches can be dated all the way back to ancient Asian civilizations; they’ve been around for hundreds of years. Yet not until recently has it been possible to place them to your clothing using a hot iron and heat-activated glue. With today’s patches it is possible to readily apply them on many fabrics without ever needing a needle and thread. Thankfully having the capacity to affix them with a hot iron implies that your fingers are not going to get sore and it is much simpler and quicker to do. The only problem is, you can’t iron patches to leather – at least in the traditional sense.
When you’re employing a hot iron to install embroidered patches you’re essentially warming up the glue on the back side till it reaches a semi liquid, tacky state. That requires a lot of heat; heat that can harm the sensitive finish of leather.
It’s correct that leather is definitely a durable material, however the surface is comfortably damaged by concentrated heat sources. This presents two problems. The first problem is the fact once the leather is damaged, the glue will not stay with it and therefore the patch will fall off. So when the patch does fall off, the leather will likely be left with the ugly mark where the iron has burned it. The same can probably be said for vinyl and various faux leather. Another thing to consider is the fact that even when you might try to create the glue adhere, one slip from the iron that can bring in touch with bare leather will leave a burn mark. This is the reason you ought to not have a hot iron anywhere near your leather.
We said earlier which you can’t use an iron to set embroidered patches to leather in the traditional sense. The explanation for saying it is because that although you must not make an effort to place iron on patches to leather within the traditional way but there’s a non-traditional method. This means that there is special glue that can be used along with an unheated iron. Yes, a smeynb iron. It are only important to apply your iron as being a press.
To acquire this to function properly, you need to have special glue; leather is notoriously difficult to work alongside so you won’t be able to use just any old glue. You will find this specialized glue at craft stores, sewing shops, and even some high-end leather goods specialty stores. Just be certain you carefully browse the directions on the bottle, making sure that use on leather products is specifically mentioned. Failure to get this done could suggest that you’re just going to be squandering your money.
The glue needs to be applied to the rear of the patch according to the instructions on the bottle and you should carefully position the patch onto the portion of the leather in which you need it. Next thing you have to do is use your cold iron to press down firmly to the patch for the amount of time as stated on the glue bottle. You may then release the iron and wait for glue to dry. It’s essential that you know where you want to have your patch before you lay it down. You will be left having an ugly stain should you take away the patch after you might have placed it on the leather.